Product Description
The CARDONE 20-61607 remanufactured power steering pump restores factory steering assist and reliability on select Jeep Grand Cherokee models. Each unit is engineered to meet or exceed OE performance and undergoes a full hydraulic efficiency test (pressure, bypass, flow, steering effort, noise). Critical components are triple-tested, sealed with 100% new HNBR O-rings, and built with precision-finished shafts and calibrated pressure relief valves for consistent, long-lasting performance. Remanufacturing also cuts energy and raw materials usage by up to 80% versus new.
Key Features
-
OE-fit reman pump, validated by full hydraulic testing
-
HNBR seals resist heat/chemical breakdown; leak-prevention focused
-
Triple-tested internals (cam packs, spool valves) for durability
-
Precision-finished shaft to minimize seal wear
-
Reservoir included for drop-in installation on supported applications
-
Eco-friendly reman process reduces material/energy use
Technical Specifications
| Specification |
Detail |
| Filter Included |
No |
| Hose Port Type |
O-Ring |
| Housing Material |
Cast Iron |
| Inlet Attachment / Diameter |
Barb / 0.423 in (10.74 mm) |
| Outlet Attachment / Thread |
Threaded / 16×1.5 |
| Pulley Attachment / Belt |
Press-On / Serpentine |
| Pulley Included |
No |
| Remote Reservoir |
No |
| Reservoir Included / Cap |
Yes / No |
| Mounting Hardware Included |
No |
| Shaft Type |
Press-On |
| Type |
Hydraulic |
OEM Cross Reference
Jeep: 5016184AA, 5080551AA, 5080551AB, 5080551AC, 52088278AB, 52088278AC
Vehicle Compatibility
Reservoir included. For warranty protection, always flush the system, install an in-line filter, and use OE-approved power steering fluid. Listed “without Aftermarket Filtration Improvement.”
Jeep
Installation & Warranty Notes
-
Flush the entire system before install to remove contaminants.
-
Use OE-approved power steering fluid only.
-
Install an in-line filter to maintain warranty and protect the pump.
-
Verify pulley press-on depth/alignment and belt condition/tension.
-
Confirm hose O-ring style and 16×1.5 outlet thread before reconnecting.